Kaidan KiWi Digital Camera Tripod Bedienungsanleitung PDF herunterladen (Seite 4)

Removing the Friction Cap

The Friction Cap needs to be removed to either install or change the

stainless steel detent discs. These discs provide the means for estab-

lishing and changing the number and spacing of the angular incre-

ments of the tripod head. Most KiWi models come with two discs, one

for the standard lens and one for a wide-angle lens. Some KiWi mod-

els, such as the KiWi 990, come with additional discs for other lenses

such as the Nikkor fisheye lens. (See List of Specfied Wide Angle

Lenses in Appendix A and List of Detent Discs in Appendix C ).

To remove the Friction Cap, loosen the stainless steel Retaining Knob

which is located on the side of the Friction Cap. It does not have to be

removed from the Cap, but only backed out far enough to allow the

cap to be unscrewed from the axle. You can look into the opening in

the center of the cap to see when the Retaining Knob is clear of the

hexagonal-shaped axle. Rotate and unthread the Cap counterclock-

wise and remove it from the unit. Once the Friction Cap has been

removed, separate the Vertical Bracket from the Indexing Hub. You

might need to wiggle the pieces as you pull them apart.

Friction Cap

Indexing Hub

Hexagonal Shaped Axle

Retaining Knob

Vertical

Bracket

Hexagonal Shaped Axle

1 2 3 4 5 6 7 8 9 ... 20 21

Keine Kommentare

Kaidan KiWi Digital Camera Tripod Bedienungsanleitung Seite 4